REPAIR CHIPPED ENAMEL - ATMOSAMAIL
Ideal for repairing enamel cracks , earthenware, porcelain
Solvent-free epoxy resin syringe
DESCRIPTION
Ideal for repairing enamel cracks , earthenware, porcelain
Solvent-free epoxy resin syringe
Solvent-free epoxy resin syringe
INSTRUCTIONS FOR USE
1 – Sand, clean, degrease and dry the surface.
2 – Cleanly cut or break the tip of the syringe.
3 – Remove the safety system between the 2 pistons. Keep this carefully as it will serve as the stopper to close the syringe after use.
4 – Press the pistons to squeeze out the required quantity of product. It must be the same amount for both components (use the plastic bubble on the packaging as a receptacle. Test first until both products begin to come out). Pull on the pistons to stop the flow.
5 – Using the spatula, mix the components well until the colour is uniform and homogenous.
6 – You now have 5 minutes to apply the product using the brush. Use the stopper to close the syringe carefully after use. Wait at least one hour before touching and 12
hours to harden completely.
2 – Cleanly cut or break the tip of the syringe.
3 – Remove the safety system between the 2 pistons. Keep this carefully as it will serve as the stopper to close the syringe after use.
4 – Press the pistons to squeeze out the required quantity of product. It must be the same amount for both components (use the plastic bubble on the packaging as a receptacle. Test first until both products begin to come out). Pull on the pistons to stop the flow.
5 – Using the spatula, mix the components well until the colour is uniform and homogenous.
6 – You now have 5 minutes to apply the product using the brush. Use the stopper to close the syringe carefully after use. Wait at least one hour before touching and 12
hours to harden completely.
+ PRODUCT
Product resistant to abrasion, detergents and hot water.
Syringe packaging for easier application
Syringe packaging for easier application
PRECAUTIONS FOR USE
Close the syringe tightly with the cap aFer use.
Wait at least 1 hour before use and 12 hours for complete hardening.
The product is relatively liquid, mask around the area of application with tape to prevent overspread and work in small touches on vertical surfaces.
The unhardened product can be cleaned off with solvent.
Wait at least 1 hour before use and 12 hours for complete hardening.
The product is relatively liquid, mask around the area of application with tape to prevent overspread and work in small touches on vertical surfaces.
The unhardened product can be cleaned off with solvent.
PARTNERS
Our products are available at stockists
