Capture d’écran 2023-06-23 à 10.03.45

LEAK PROOF PATCH

Repairs and seals
For all materials
Sets in 15 minutes

DESCRIPTION

Repairs and seals
For all materials
Sets in 15 minutes

INSTRUCTIONS FOR USE

1 – Turn off the water supply and dry the surface as much as possible.
2 – Use the gloves provided when handling the product.
3 – Sand and clean the surface to be sealed before applying the patch.
4 – The wider side of the patch (8cm) should be positioned parallel to the surface.
5 – Open the aluminum pouch and remove the patch from its protective film.
6 – Apply the leak-proof patch to the surface to be repaired by stretching it along the edges and pressing down on the corners and sides.
7 – Lightly moisten the patch, e.g. with a spray bottle.
Sets in: 15 mins – Fully cured in: 12 hours.

TIPS

The product should not be rolled up on itself, nor should it be used for angles or elbow joints.
It must be applied on a flat surface. Not suitable for diameters less than 80 mm.
For smaller diameters, use the ATMOSOLUTION PIPE REPAIR BANDAGE.
Once the aluminum packaging has been opened, the product must be used immediately.
It cannot be re-used.
Suitable for pressures of up to 5 bars and temperatures of up to 320°C.

PARTNERS

Our products are available at stockists

RANGES

OUR SIMILAR PRODUCTS