1- Sand, degrease, clean and dry the surface to be repaired.
2- Cut the ribbon to the desired length and remove the clear protective paper. Warning: Plan to cover at least 5 cm on each side of the area to be repaired.
3- Position the tape before the area. Hold the end of the tape firmly to the surface and wind the tape as far as it will go. Make a first turn on itself to secure the application.
4- Then apply in a spiral with an overlap of at least 50%, always stretching the tape. Make at least two round trips (3 layers).
5- Pay attention to the ends to ensure as perfect contact as possible between the surfaces.
The tape begins to vulcanize immediately. Not repositionable. For a quick, temporary or permanent repair (wait 24 hours).
If the ribbon breaks during use or runs out, continue with another piece. The latter will
amalgamate with the first.